Skip to content
254 Engineering Services
Contact the Firm

Careers

Build a Texas engineering firm from the ground up

254 Engineering LLC is a veteran owned firm named for the 254 counties of Texas and built to serve every one of them, on licensed professional judgment and statewide field operations. These are the seats that make that possible.

Timber framing of a house standing against an open sky.

Working here

What the operating model means for you

The firm is built on written protocols, central engineering review, and its own operations software. That is the pitch to a buyer. This is what each of those four things means for the person doing the work.

The work runs to written protocols

Every service line has a documented inspection procedure that says what is measured, what is photographed, in what order, and what is recorded when a condition cannot be observed. Technicians are certified on a protocol before a first assignment on it. Written protocols rather than individual habit is what lets one person's record be read by somebody who was not there.

A licensed engineer sits at the center

Field work gathers evidence and does not reach conclusions. A Texas licensed Professional Engineer reads the record, forms the opinion, and takes responsible charge of the sealed document. Responsible charge is never asked to bend: if a record does not support an opinion, the answer is that it does not, and the job goes back to the field.

Technology in the boring places

Dispatch, protocol capture, review queues, and delivery run on systems the firm builds rather than on a phone tree and a shared drive. For a technician that means an assignment arrives with the protocol attached and the evidence uploads from the property. For an engineer it means a review is reading evidence rather than chasing it.

The whole state, genuinely

All 254 counties, grouped into eight regions on the lines that already organize permitting and emergency management. For a technician that means claiming the counties you can actually reach, including places most firms never dispatch to. For an engineer it means volume from every part of Texas rather than from one metro.

The honest stage

This is a firm at launch. There is no office, no team photograph, and no headcount, because there are none of those things yet. Somebody who wants to inherit a working system should not apply. Somebody who wants to set how one works should read the seats below, because the person who takes them writes the standard rather than following it.

How we engage

Two engagement models, stated up front

Which one applies depends on the seat, and neither is discovered at the offer.

Retainer or salaried, as the seat requires

Professional roles

The engineering seat is a professional engagement with the firm, structured as a retainer against a defined review commitment while the volume is being built, and written to grow with what it reviews. What that growth looks like is written into the agreement rather than described in an interview.

  • Engaged directly by the firm rather than through an agency.
  • Remote, from anywhere in Texas.
  • Responsible charge is not shared and not delegated.

Independent contractor, per completed inspection

Field technician engagements

Field inspection work is independent contractor work, stated up front rather than discovered at the offer. Jobs are dispatched and you accept or decline each one, with no obligation either way and no penalty for declining.

  • Flat rate per completed inspection, agreed per service line before you take an assignment on it.
  • No minimum volume and no exclusivity.
  • You control the manner and means of the work within the written protocol, supply your own vehicle and equipment, and are responsible for your own taxes, insurance, and business expenses.

Open positions

2 open positions

Both are described as they actually are, including the engagement model and the parts people usually find out about late.

The process

What happens after you apply

6 steps. You should be able to predict your next two weeks from this list.

  1. 01

    Application review

    You complete the application for the role. It takes about ten minutes and it asks for the things that decide the answer: your license or your background, the counties you can reach, and your documents. Nothing is asked twice. A person reads every one, not a filter.

  2. 02

    Credential verification

    For licensed roles the license is checked against the public roster the Texas Board of Professional Engineers and Land Surveyors publishes, and any windstorm appointment against the Texas Department of Insurance. Public records only. Nothing is requested from you that a public source already answers.

  3. 03

    Phone interview

    A short call about the work itself. For engineers, what you will seal and what you will not. For technicians, the counties you would genuinely drive to and what you have inspected before.

  4. 04

    Video interview and identity

    A longer conversation covering the engagement, the protocols, and how review works. This is where you should ask the awkward questions about volume and pay, because the answers are better heard now. Identity is confirmed on this call, which for a remote firm dispatching people to private property is a floor rather than a formality.

  5. 05

    Offer and written agreement

    A written agreement stating the engagement, the rate or retainer, and the obligations on both sides. Nothing about the arrangement is left to be understood.

  6. 06

    Onboarding

    Document collection and protocol certification run through the firm's secure portal rather than over email. Background verification, where a role requires it, happens after an offer is accepted and is handled directly with you.

Standards and integrity

What a licensed engineer is protected by here

The reason an engineer would take a seat at a firm this young is that the arrangement is written down rather than promised. These four are contractual, not cultural.

The engineer writes the standard

Protocols are authored and owned by the licensed engineer whose seal depends on them, not handed down by operations and not written by whoever built the software. An engineer who cannot change the procedure that produces their evidence is an engineer being asked to rely on somebody else's judgment.

Refusal is a contractual right, not a favour

If the record does not support an opinion, the answer is that it does not, and the job goes back to the field. Nobody in this firm is authorized to ask an engineer to seal past that, and the engagement says so in writing.

Responsible charge means what the rule says

Texas defines responsible charge as control over the work and detailed professional knowledge of it. Neither is satisfied by receiving a finished document and forming a general impression that it looked reasonable. The separation between field capture and engineering review exists so that the licensee genuinely has both.

Volume never sets the standard

The commercial pressure in a review model is always toward faster sign off. The structural answer is that the review commitment is defined in the agreement and the refusal right sits above it, so a busy week changes the queue rather than the threshold.

Questions

Questions candidates actually ask

What kinds of engagement does the firm offer?
Two. Professional roles, currently the engineering seat, are engaged directly by the firm as a retainer against a defined review commitment. Field inspection work is independent contractor work, dispatched job by job at a flat rate per completed inspection, with no minimum volume and no exclusivity.
Is the engineering role remote?
Yes, from anywhere in Texas. The review model is built around reading a standardized record rather than visiting properties, so the seat does not require proximity to any metro. Field technician work is the opposite: it happens at the property.
Which parts of Texas does the firm dispatch to?
All 254 counties, grouped into eight regions. Technicians choose the counties they are willing to serve and are dispatched only within them. Rural county groups are where technician density is thinnest and where coverage is worth the most to the firm.
What license does each role require?
The engineering seat requires an active Texas Professional Engineer license in good standing. The field inspection role requires no license at all: it requires a reliable vehicle, comfort working safely around a roof, thorough documentation, and certification on the written protocol for each service line before a first assignment on it.
How does field dispatch actually work?
An assignment arrives with the protocol for that service line attached. You accept or decline it, with no obligation either way and no penalty for declining. Evidence is captured to the protocol and uploaded from the property. What you earn on a job is known when you accept it rather than worked out afterward.
How is the engineering seat compensated?
As a retainer against a defined review commitment, with a per document component as volume builds. The structure is agreed with the selected engineer and written into the agreement. Specific figures are settled in the offer conversation rather than published, because the review commitment they attach to is agreed at the same time.
Does the firm support a TDI windstorm appointment?
Yes. A windstorm inspection appointment from the Texas Department of Insurance is not required for the engineering seat and is a considerable plus. For an engineer willing to pursue one, the firm supports the application, covers the cost, and provides the coastal volume that makes it worth holding.
How long does a reply take?
Every application receives a response. The firm is small and reads applications in batches rather than daily, so a reply is a matter of days rather than hours, and a slow reply is not a silent rejection.
Is the firm registered and practising today?
Yes. The firm is registered with the Texas Board of Professional Engineers and Land Surveyors and a licensed engineer is in responsible charge.

Equal opportunity

How applications are read

Applications are read by a person and considered on the qualifications the role actually requires. 254 Engineering LLC does not discriminate on race, color, religion, sex, sexual orientation, gender identity, national origin, age, disability, genetic information, veteran status, or any other basis protected by federal or Texas law.

The firm is veteran owned, which is a statement about who owns it and not a preference applied to hiring.

If you need an accommodation at any point in the process, say so in the application or in reply to any message from the firm, and it will be arranged.

The application asks for nothing sensitive. No social security number, no date of birth, no identity documents, and no bank details are collected by this website. A background check may be requested later in the process, and if it is, it is handled directly with you rather than through a form.